The MC110CS will transmit at extended fibre optic distances utilising single-mode fibre up to 20 kilometres. Other features of this module include the ability to be used as a stand alone device (no chassis required) or with TP-LINK´s 19 inch system chassis, Auto MDI/MDI-X for TX port, Auto negotiation of duplex mode on TX port and front panel status LEDs. It works at 1310nm on both transmitting and receiving data. #Multimode media converter fullThe MC110CS supports longwave (LX) laser specification at a full wire speed forwarding rate. Designed under IEEE 802.3u 10/100Base-TX and 100Base-FX standards, the MC110CS is designed for use with single-mode fibre cable utilising the SC-Type connector. The MC110CS is a media converter designed to convert 100BASE-FX fibre to 100Base-TX copper media or vice versa. Storage Humidity: 5% to 90% non-condensing Operating Humidity: 10% to 90% non-condensing Provides switch configuration of Half-Duplex / Full-Duplex transfer mode for FX port Link Fault Passthrough and Far End Fault minimise the loss caused by link failure timely The MC100CM will transmit at extended fibre optic distances utilising multi-mode fibre up to 2 kilometres.Ĭomplies with 802.3u 10/100Base-TX, 100Base-FX standards The MC100CM supports longwave (LX) laser specification at a full wire speed forwarding rate. Designed under IEEE 802.3u 10/100Base-TX and 100Base-FX standards, the MC100CM is designed for use with multi-mode fibre cable utilising the SC-Type connector. The MC100CM is a media converter designed to convert 100BASE-FX fibre to 100Base-TX copper media or vice versa.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |